Your Keychain Transmitters - Audiovox PS-130I Owner's Manual

YOUR KEYCHAIN TRANSMITTERS:

The transmitters included with this security system are pre-programmed at the factory,
with button assignments (channels) prioritized in a standard format. You can select which
transmitter button controls a particular function, (see the transmitter programming guide).
This manual explains the operation of the system assuming that the transmitter buttons are
prioritized in their standard, factory pre-set format.
ARMING THE SYSTEM (CHANNEL 1): ACTIVE
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. Press and release button #1 on the keychain transmitter. The siren will "chirp" once,
the doors will lock (optional), and the dash mounted LED will begin to slowly flash.
WARNING ! Excessive pressure on the transmitter button will damage the
internal components on the circuit board. All that is required is a
light push to the button.
NOTE: If the siren "chirped" three times when ARMING, then one of the entry points
(hood, trunk, doors) has been left opened. Closing the Hood, trunk, or door will correct
the problem, and you DO NOT have to disarm the system to make the correction.
ARMING THE SYSTEM (CHANNEL 1) : PASSIVE
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. The dash mounted L.E.D. will begin flashing rapidly, indicating that the system is
automatically (passive) arming. As an added convenience, the automatic passive
arming will not begin until all doors and trunk lid are closed, allowing passengers to
exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single, short "chirp" from the siren, indicating the system
is ARMED. At this time, the dash mounted L.E.D. will begin to flash slowly, providing
a visual indication that the system is fully ARMED.
3A. If the optional parking light flasher has been installed, the vehicles parking lamps
will flash 1 time when the system arms.
3B. If the optional door lock interface has been installed, the doors WILL NOT
automatically lock when the 30 second arming time expires.
4. If you wish to ARM the system immediately, simply press and release button #1 on the
keychain transmitter. The siren will "chirp" once, the parking lamps will flash once
(optional), the doors will lock (optional), and the dash mounted L.E.D. will begin to
slowly flash.
Page 2