Motorola GM1200E Installation Manual page 17

To fit the remote back housing:
1. Connect the flex to the control head back housing PCB (i.e. original PCB inside control head).
2. Press the control head onto the remote back housing until it snaps into place.
Remote Front Housing
Front housing PCB
Pad
Remote mount
Radio front housing
Gasket
Remote cable
To install the remote control head into the vehicle:
1. Position the remote mount bracket in the desired location and mark the positions of the
mounting holes, centrepunch the marked spots and drill a 4 mm Ø hole at each mark. Mount
the trunnion with the supplied screws.
2. Ensure the socket gaskets are in the back of control head and radio front housing and
connect the remote mount cable to both connectors.
3. Snap the control head into the mounting trunnion and fix it with the wing screws.
For more information on the remote mount kit please refer to the accessory chapter in the
Basic Service Manual (section 5 of the Product Manual).
Radio Installation
Remote
mount
radio
Flex connector
Flex connector
interface
Controlhead
Figure 1-9 Control Head Remote Mount Kit.
Gasket for
Remote cable socket
Remote Controlhead
back housing
Controlhead
Radio Mounting
Bracket
Remote mount
Gasket
Controlhead
PCB
Remote Back Housing
1-11