External Speaker Installation; Remote Mount Controlhead Installation - Motorola GM1200E Installation Manual

Radio Mounting
6.5

External Speaker Installation

1. Remove the speaker from the trunnion bracket by loosening the two wing screws.
2. Choose a place to mount the speaker.
3. Using the trunnion bracket as a template, mark the locations of the three mounting holes.
4. Centrepunch and drill a 4 mm Ø hole at each location.
5. Mount the trunnion bracket with the screws supplied (Figure 1-8).
6. Insert the speaker into the trunnion bracket and tighten the two wing screws.
7. Insert the external speaker accessory plug into the accessory connector of radio.
6.6

Remote Mount Controlhead Installation

To remove the front housing:
1. Remove the control head from the radio using a flat blade screw driver. Insert the screw driver
in the recess between the control head and the radio. Press until the side of the control head
releases.
2. Pull the control head away from the radio. Remove the flex connector from the socket on the
control head side.
3. Take the remote mount front housing and connect the flex connector to the radio front housing
PCB. The contact surface of the flex should be facing the PCB.
4. Press the front housing onto the radio chassis until the protuding taps on radio chassis snap
into the recesses inside the front housing.
1-10
Dashboard
Firewall
Figure 1-8 Mounting Speaker under the Dashboard.
Trunnion Bracket
OR
Radio Installation