Page 1
Model APS-45 Owner's Manual 2 Button Remote Keyless Entry System With Two Auxiliary Outputs FEATURES: 2 Two Button, 3 Channel RF Transmitters Three Channel Code Learning Receiver Remote Panic In All Modes Built-In Parking Light Output LED Status Indicator Ignition Door Locking/Unlocking...
Page 2
If the optional Starter Interrupt relay has been installed, then whenever the system is armed, the vehicle starter circuit is disabled, even with the ignition key, the vehicle will not start. Should an attempt be made to start the engine, while the APS-45 is armed, the starter circuit will remain interrupted.
Page 3
Two Step unlocking is an optional feature that must be wired upon installation. VALET / PROGRAM / MANUAL OVERRIDE SWITCH The valet switch allows you to temporarily prevent the APS-45 from arming, eliminating the need to hand your keychain transmitter to parking attendants or garage mechanics.
Page 4
Note: In the event that you lose your keychain transmitter or the transmitter fails to operate the keyless entry system, the valet switch can be used to override the optional Starter Interrupt, and therefore allow the engine to be started. To override system: 1.
Page 5
To discontinue the output, simply release the transmitter buttons. IGNITION DOOR LOCKING/UNLOCKING The APS-45 system is capable of being programmed for the added safety and security of ignition controlled door locking and unlocking. These features are separate, so the APS-45 may be programmed for one, or both, or neither.