Table of Contents
Advertisement
Quick Links
ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors,
hood lid and trunk lid.
2. Press and release Lock/Arm button on the keychain
transmitter.
The dash mounted LED begins to flash slowly. Parking
Lights flash one time.
Siren sounds one chirp.
If the siren/horn sounds 3 chirps, then you have left a door,
trunk, or hood lid ajar. Simply close the opened entry point
to provide full protection. If the siren "chirped" three times,
sometime after arming, the exclusive, patented, delayed dome light
learn circuit has been programmed and the system detected a open
entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to dis-
arm the system to make the correction. If the siren/horn did not
sound when arming, then the chirps have been turned off and you should refer to the
section titled "ELIMINATING THE ARM/DISARM CHIRPS" in this manual.
NOTE: If selectable feature 9, Chirp Delete From Transmitter, was set to the on position
during installation, then you can selectively defeat the arm & disarm chirps by holding
the transmitters Lock or Unlock button for about 2 seconds.
Note: If Passive Arm Mode was selected on during installation, then 30 seconds after
the last vehicle door is closed, the unit will arm automatically.
PROTECTION WHILE THE SYSTEM IS ARMED
Opening any protected door, hood or trunk lid will cause the alarm to immediately sound. The
alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry
points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed
and ignore that triggered zone.\
Whenever the system is armed, the dash mounted LED indicator will slowly flash. This serves as
a visual deterrent to the potential thief. The LED is a very low current bulb and will not cause the
vehicle's battery to drain, even when left unattended for extended periods.
Whenever the system is triggered, the vehicle's parking lights will flash for the full 30 second
alarm cycle, attracting visual attention to the vehicle.
Optional - Whenever the system is armed, the vehicle's starting circuit will be bypassed. If the thief
should choose to ignore the siren, the vehicle can not be started.
Any mild impact to the vehicle's glass will cause the alarm to sound a short series of warning
tones.
Any strong impact to the vehicle's glass will cause the alarm to trigger for the full 30 second alarm
cycle.
NOTE:
If the optional interior illumination circuit was installed, the interior light will flash as well
for the full 30 second alarm cycle.
DISARMING THE SYSTEM
1. As you approach the vehicle, press and release the Unlock/Disarm button on the keychain
transmitter.
The dash mounted LED turns off. If passive arming is selected on, the LED will start flashing
rapidly, indicating that the system is re-arming automatically. Open any door to suspend the
automatic arming. Parking Lights flash two times. If the parking lights flashed three times,
then the alarm was triggered in your absence. Before turning the key on, examine the LED to
identify which zone was triggered. Siren sounds two chirps. If the siren sounds 4 chirps, then
the alarm was triggered in your absence. Before turning the key on, examine the LED and refer
to the INTRUSION WARNING SIGNALS section of this manual to identify which zone was
triggered.
If the siren did not sound when disarming, then the chirps have been turned off
and you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS" in this
manual.
Doors Unlock - Optional
NOTE: If the optional Interior illumination feature has been added as an added convenience, the
system will turn on the interior lights when the system is disarmed.
Rev A: Remove warranty from manual. 6/07
Model APS-920
Owner's Manual
128-7852A
1 of 10
Advertisement
Table of Contents
Related Manuals for Audiovox Prestige 128-7852A
Summary of Contents for Audiovox Prestige 128-7852A
- Page 1 ARMING THE SYSTEM - ACTIVE 1. Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid. 2. Press and release Lock/Arm button on the keychain transmitter. The dash mounted LED begins to flash slowly. Parking Lights flash one time.
-
Page 2: While The System Is Sounding
WHILE THE SYSTEM IS SOUNDING If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the Unlock/Disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children playing near your vehicle that may accidently trigger your security system. - Page 3 If the new code was accepted, the unit will report back the newly entered code, by flashing the LED, first indicating the 10ths digit, pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming.
-
Page 4: Eliminating The Normal Arm / Disarm Chirps
THE OPTION BUTTON of your transmitter may or may not be used with your system but may be used with a second similar Audiovox Model system that may be installed on a second vehicle in your family. OPERATING ON AUTOMATIC START UP TIMER MODE Your system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. - Page 5 button for two seconds. If you find the normal arming and disarming chirps annoying, they can be turned off permanently, eliminating the need to hold the ARM / DISARM button for 2 seconds. To do this, 1. Turn the ignition key on then off. 2.
-
Page 6: Turbo Timer Mode
the device indicated, momentarily press, or press and hold the appropriate transmit- ter button(s) as indicated above. TURBO TIMER MODE This system provides a means to cool down the vehicles turbo charger, if so equipped, by allowing the vehicle to continue to run for a prescribed period of time every time the vehicle's engine is turned off. -
Page 7: Battery Replacement
1) Enter the transmitter program mode of channel 1 as indicated above. 2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a chirp, then release and immediately press the same button a second time until you hear a long chirp followed by a short chirp. - Page 8 Vehicle as Been Started By Remote Control. Vehicle Is Running Under Control of The Remote Start Unit. Battery Save Mode Is On. Battery Level Indicator, Shown At Full Level. Hood Or Trunk Input Was Activated. Door Input Was Activated. Vibration Sensor Was Activated. Pre Detect Stage Of Sensor Was Activated.
- Page 9 CAUTION!! CARBON MONOXIDE GAS CAN CAUSE SERIOUS INJURY AND EVEN DEATH It is the sole responsibility of the user to operate the vehicle this system is installed in a safe manner. This device must not be used in an enclosed space like a garage, attached or de- tached, car port, or any partially enclosed areas.
- Page 10 Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. 9) Mail this form along with your payment to: Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y., 11788 Attn.: TRANSMITTER DEPARTMENT Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, NY 11788 APS620CF $65.00...