Advertisement
Quick Links
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions. Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
3. Awl or similar tool
5. 18 GA wire 9'
7. 5/16" Hex Socket Bit
9. Pencil or equivalent
11. Masking tape
128-6067
INSTALLATION INSTRUCTION # 44-0091A
INSTALLATION INSTRUCTIONS
55-0401x-121 SERIES 1187001PL
2001 DURANGO
NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.
FOR
2. Powered screwdriver or drill with adapter
4. Digital Volt Meter
6. Rubbing Alcohol
8. Razor knife or similar
10. Measuring tape
12. Audiovox Video Module
Feb. 13,2001
Printed in the U.S.A
Advertisement
Related Manuals for Audiovox 1187001PL
Summary of Contents for Audiovox 1187001PL
-
Page 1: Installation Instructions
11. Masking tape NOT FOR VEHICLES EQUIPPED WITH SUN ROOF. 128-6067 INSTALLATION INSTRUCTION # 44-0091A INSTALLATION INSTRUCTIONS 55-0401x-121 SERIES 1187001PL 2001 DURANGO 2. Powered screwdriver or drill with adapter 4. Digital Volt Meter 6. Rubbing Alcohol 8. Razor knife or similar 10. - Page 2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, #8 X 9/16" PWH SCREW, # 10 X 1/2" HWH,TEK SCREW, 6-32 X 3/4" ,PPH WASHER, 3.5 mm MOUNTING BRACKET CONSOLE TEMPLATE INSTALLATION INSTRUCTION # 44-0091A Feb. 13,2001 Printed in the U.S.A.
- Page 3 I. PREPARATION OF VEHICLE INTERIOR 1. Remove and retain rear A/C controls by pulling downward. Disconnect wire harness. See Figure 1. Set controls in a safe place for reuse later. FIGURE 1 2. Cut template (item 7 pg 2) in area #1. Locate and tape template to the headliner.
- Page 4 4. Carefully pull (3) A/C wire harness clips from roof brace to extend length of wire harness. It may be necessary to lower the driver’s side of headliner at the “B” pillar to gain access to the 3 Use caution when pulling on wire harness and pulling downward on headliner.
- Page 5 FIGURE 7 9. Install A/C switch into rear of console (item 6 pg2) and O.E. bracket over A/C switch. Make sure control snaps securely into bracket. See Figure 8. 10. Secure bracket to console brace using (2) two # 8 x 9/16"...
-
Page 6: Installation Of Console
FIGURE 9 14. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing. 15. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instructions included with video system.