Advertisement
FIGURE 9
14. Release video screen from locked position.
Lower video screen to viewing position for
access to mounting locations in top of video
system housing.
15. Raise video system into approximate position
and connect all wiring to components. Connect
wiring and cabling to video system per
instructions included with video system.
16. Check function of all components and lights. See
operating instructions for video system
operations check. For further assistance, refer to
the video system manual for the technical
support phone number listed for your area.
17. Insert video system into opening in console. Note: Make sure wires do not get pinched between video
system and console. Align holes in housing with holes in mounting bracket. Secure using (4) four 6-32 x
3/4"screws and (4) four 3.5 mm washers (items 3&4 pg2). See Figure 10.
Caution: Do not overtighten screws.
18. Raise video screen into locked position.
II. INSTALLATION OF CONSOLE
11. Raise console (item 6 pg 2) into approximate
12. Insert plastic flange on rear of console into
13. Secure console secure front of console using (2)
6
position against headliner. Connect O.E. wiring
to A/C control.
opening in headliner. Make sure console is
centered left to right. See Figure 9.
two 6-32 x 3/4" screws (item 3 pg 2).
FIGURE 10
Advertisement
