Advertisement
I. PREPARATION OF VEHICLE INTERIOR
1. Remove and retain rear A/C controls by pulling
downward. Disconnect wire harness. See Figure 1.
Set controls in a safe place for reuse later.
FIGURE 1
2. Cut template (item 7 pg 2) in area #1. Locate and
tape template to the headliner. Make sure
template is centered left to right in vehicle and
mark area to be cut. Remove template and trim
headliner. Cut template areas #2 & #3 and
reinstall the template to the headliner. Ensure area
#1 of the template hole locations are aligned with
the OEM bracket holes. Mark and trim headliner.
The rear cutout is critical, do not overcut or
the opening will be visible when the console is
installed. See Fig. 2. Caution: Before cutting
headliner material, check for wiring or other
componentry above headliner. Cut only where
FIGURE 2
indicated.
3. Remove and retain O.E. A/C switch bracket and
screws. See Figure 3.
FIGURE 3
3
Advertisement
