11. Masking tape NOT FOR VEHICLES EQUIPPED WITH SUN ROOF. 128-6067 INSTALLATION INSTRUCTION # 44-0091A INSTALLATION INSTRUCTIONS 55-0401x-121 SERIES 1187001PL 2001 DURANGO 2. Powered screwdriver or drill with adapter 4. Digital Volt Meter 6. Rubbing Alcohol 8. Razor knife or similar 10.
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, #8 X 9/16" PWH SCREW, # 10 X 1/2" HWH,TEK SCREW, 6-32 X 3/4" ,PPH WASHER, 3.5 mm MOUNTING BRACKET CONSOLE TEMPLATE INSTALLATION INSTRUCTION # 44-0091A Feb. 13,2001 Printed in the U.S.A.
Page 3
I. PREPARATION OF VEHICLE INTERIOR 1. Remove and retain rear A/C controls by pulling downward. Disconnect wire harness. See Figure 1. Set controls in a safe place for reuse later. FIGURE 1 2. Cut template (item 7 pg 2) in area #1. Locate and tape template to the headliner.
Page 4
4. Carefully pull (3) A/C wire harness clips from roof brace to extend length of wire harness. It may be necessary to lower the driver’s side of headliner at the “B” pillar to gain access to the 3 Use caution when pulling on wire harness and pulling downward on headliner.
Page 5
FIGURE 7 9. Install A/C switch into rear of console (item 6 pg2) and O.E. bracket over A/C switch. Make sure control snaps securely into bracket. See Figure 8. 10. Secure bracket to console brace using (2) two # 8 x 9/16"...
FIGURE 9 14. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing. 15. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instructions included with video system.