Hyundai sonata Owner's Manual page 179

Programming
To program most devices, follow these
instructions:
1. Press and release (1), (2) or (3) button.
• I f the indicator (4) is turned ON in
Orange, go to Step 3) since it is a
new programming.
• I f the indicator (4) is continuously
turned ON or flashes in Green rapidly
several times, go to Step 2) since it is
a programmed button.
2. Press and hold the button you wish
to program for approximately 15-
25 seconds until the LED flashes in
Orange for several times.
3. Hold the Garage Door Opener Original
Transmitter near the HomeLink Mirror.
4. Press the Original Transmitter
button until the indicator (4) is
turned continuously ON or flashes in
ODN8A059136
Green for approximately 10 seconds
and it indicates the programing is
completed.
5. However, the indicator (4) flashes
in Green continuously, but if the
garage door opener does not operate,
please continue to follow the step 6
and 7 ("Rolling Code Programming"
procedures).
6. Firmly press and release the "Learn,"
"Smart," or "Program" button while
the indicator (4) flashes in Green.
Once the button is pressed, you have
approximately 30 seconds to initiate
the next step.
Information
At the garage door opener motor, (security
gate motor, etc.) locate the "Learn,"
"Smart," or "Program" button. This
can usually be found where the hanging
antenna wire is attached to the motor-head
unit (see the device's manual to identify
this button). The name and color of the
button may vary by manufacturer. A
ladder and/or second person may simplify
the following steps.
05
ODN8A059137
5-49