Cleaning And Maintenance; Max Transmission Time; Automatic Power Off; Microphone Input - 3M Peltor WS LiteCom Plus Manual

EN

2:15 Max transmission time

This function lets you adjust the maximum transmission time.
You can choose between 30 seconds up to 5 minutes and
off-mode. Each change is confirmed by a voice message
("OFF", "30s", "1min", "2min", "3min", "4min", "5min")
Default: 3 min

2:16 Automatic power off

The automatic power off is the time that elapses before the
headset is automatically powered off if there is no activity
(button presses or VOX activation).
Before the headset powers off you will hear a voice message and
warning beeps. The warning lasts for 10 seconds, then the
product is powered off. To abort the automatic power off function,
press any button.
("OFF", "30 min", "60 min", "2 h", "4 h", "8 h")
Default: 4 h

2:17 Microphone input

This product is supplied and calibrated for use with a dynamic
microphone (MT73) as standard. You can however adjust the
microphone gain here. It is also possible to switch off the
microphone and just use the headset for listening. Each
change is confirmed by a voice message.
("OFF", "Low", "Medium", "High")
Default: Medium
2:18 External jack input sensitivity level control
Level control for incoming signal from external equipment
connected to the external jack. Each change is confirmed by
a voice message.
("OFF", "Low", "Medium", "High")
Default: OFF
*2:19 Bluetooth streaming
®
Enable or disable the streaming function.
Default: Enable
*2:20 Bluetooth Multipoint
®
Enable or disable the Multipoint function.
Default: Enable
2:21 Reset to factory default (fig.11)
To confirm a reset to factory default, hold the plus button for
two seconds. This is confirmed by the voice message "power
off".
7

3. CLEANING AND MAINTENANCE

Use a cloth wetted with soap and warm water to clean the
outer shells, headband and ear cushions.
NOTE: Do NOT immerse the hearing protector in water.
If the hearing protector gets wet from rain or sweat, turn the
earmuffs outwards, remove the ear cushions and foam liners,
and allow to dry before reassembly. The ear cushions and
foam liners may deteriorate with use and should be
examined at regular intervals for cracking or other damage.
When used regularly, 3M recommends replacing the foam
liners and ear cushions at least twice a year to maintain
consistent attenuation, hygiene, and comfort. If an ear
cushion is damaged, it should be replaced. See spare parts
and accessories section below.
3:1 Removing and replacing the ear cushions
D:1 To remove the ear cushion, slide your fingers under the
inside edge of the ear cushion and firmly pull straight out.
D:2 Remove existing liner(s) and insert new foam liner(s).
D:3 Fit one side of the ear cushion into the groove of the
earcup and then press on the opposite side until the ear
cushion snaps in place.
3:2 Use and storage conditions
Remove the batteries before storing the product. Do not
store the hearing protector at temperatures above 55 °C or
131 °F, (for example on a dashboard, parcel shelf or window
sill), or at temperatures below –20 °C or –4 °F. Do not use
the hearing protector at temperatures above 55 °C or 131 °F,
or below –20 °C or –4 °F.
* Only WS (Bluetooth ) models
TM ®