Setting Monitor - Audiovox LCM580NAV User Manual

Setting monitor

The colour display is equipped with OSD prompting for the monitor settings.
Invoking OSD menu
— Briefly press the MENU button at the top of the monitor.
The OSD menu "Navigation Settings" is displayed.
In the OSD menu you can carry out the following settings:
• Volume:
• Brightness:
• DisplayMode:
Adjusting settings
— Press the MENU button until the desired menu item appears.
— Carry out the desired setting with the
If necessary, invoke the next menu item by pressing the MENU button and carry out
the settings.
If you use the built-in monitor loudspeaker leave the volume level in the OSD
menu on the middle setting. Adjust the volume level for the audible messages of the
navigation system only with the
The volume level of the built-in monitor loudspeaker can also be set without
invoking the OSD menu. To do so:
+ -
— Press or button on the monitor.
The display automatically changes to the menu for setting the volume level.
— Set the volume as required.
Quitting OSD menu
To quit the OSD menu press the MENU button until the menu is hidden.
If a button has not been pressed for several seconds, then the OSD menu is auto-
matically hidden again.
Volume level of the built-in monitor loudspeaker
Brightness of the display
Screen display; the selected setting is indicated with a yellow
bar. Possible selections include:
"Full Screen" (16:9)
"Normal" (4:3)
+ -
or
+ -
or buttons.
buttons on the remote control.
Setting monitor
3