Audio Mute - Audiovox PCD120U Owner's Manual

PCD120U
OPERATING INSTRUCTIONS
Bass Control
4
To adjust the bass level, press the SEL/MENU
button (4) until "BAS" appears on the display
panel. Within five seconds, press the VOL
buttons (3a and 3b) to adjust the bass from
"BAS -6" to "BAS 06". "BAS 00" represents a
flat response.
Treble Control
4
To adjust the treble level, press the SEL/MENU
button (4) until "TRE" appears on the display
panel. Within five seconds, press the VOL
buttons (3a and 3b) to adjust the treble from a
minimum of "TRE -6" to a maximum of "TRE
06". "TRE 00" represents a flat response.
Left/Right Balance Control
4
To adjust the left-right speaker balance, press
the SEL/MENU button (4) until the "BAL"
indication appears on the display panel. Within
five seconds, press the VOL buttons (3a and
3b) adjust the balance between the left and
right speakers from "BAL 12L" (full left) to "BAL
12R" (full right). "BAL L=R" represents an equal
balance level between the left and right
speakers.
Front/Rear Fader Control
4
To adjust the front/rear speaker balance, press
the SEL/MENU button (4) until "FAD" appears
on the display panel. Within five seconds, press
the VOL buttons (3a and 3b) to adjust the
balance between the front and rear speakers
from "FAD 12F" (full front) to "FAD 12R" (full
rear). "FAD F=R" represents an equal balance
level between the front and rear speakers.
Loudness Control (BND/LOU)
5
When listening to music at low volumes, this
feature will boost the bass and treble ranges to
compensate for the characteristics of human
hearing. Press and hold the BND/LOU button
(5) to activate this feature as indicated by
"LOUD ON" on the display panel. Press and
hold the BND/LOU button again to deactivate
the function and "LOUD OFF" will appear on the
display.
AM/FM Band Selector
5
During radio play, press the BND button (5) to
change the radio band. The indications "AM" or
"FM" appear on the display panel according to
your selection.
7
Manual Tuning Control
6
Turn the manual tuning (TUN) control (6) to
tune upward in frequency on the band in use or
counter-clockwise to tune downward in
frequency. The frequency to which you are
tuned will be shown in digital format on the
display panel. When tuning in a station, always
adjust the control so that the correct broadcast
frequency is shown on the display and you are
receiving a clear signal. If the radio is tuned off-
frequency, you could experience distorted
audio, noise and other reception problems.
Mode Button (MOD)
7
The MOD button (7) enables selection of radio
or disc play. When a CD is playing, press the
MOD button to revert to radio operation.

Audio Mute

8
Press the MUTE ( ) button (8) to mute the
radio volume from the system. "MUTE" will
appear on the display panel and the volume will
be muted. (If you press this button while a CD is
playing, CD play will be paused.) Press MUTE
again, or press the VOL buttons (3a and 3b) or
the SEL/MENU button (4) to return the volume
level to the setting in use before the mute
function was activated.