6
GEAR HOUSING – SECONDARY SHAFT
1
3
10
2
4
Dismantling
Starting position
Lift off the spacer ring and brass washer at the top of
the secondary shaft if this has not already been done.
Remove the spindle shaft gear wheel, see Page 12.
Remove the complete primary shaft, see Page 7.
Remove the gear knob
1. Remove the cotter pin with a punch and remove the
knob.
2. Remove the spring.
3. Remove the circlip.
4. Press out the gear selector.
Reassembly
Check that the O-ring is intact. Grease the O-ring and
the gear selector's contact surfaces facing the gear
housing.
Turn the gear selector with the shift pin facing down.
If the machine is placed with a tool attachment facing
down (see Page 4) the pin will automatically be in the
correct position to the shift wheel on the secondary
shaft.