Quick Start Guide
6
Set the switches
Set simulate and security switch configuration before installation as shown
in
Figure
•
The simulate switch enables or disables simulated alerts and simulated
AI Block status and values. The default simulate switch position is
enabled.
•
The security switch allows (unlocked symbol) or prevents (locked
symbol) any configuration of the transmitter.
•
Default security is off (unlocked symbol).
•
The security switch can be enabled or disabled in software.
Use the following procedure to change the switch configuration:
Procedure
1. If the transmitter is installed, secure the loop, and remove power.
2. Remove the housing cover opposite the field terminal side. Do not
remove the instrument cover in explosive atmospheres when the
circuit is live.
3. Slide the security and simulate switches into the preferred position.
4. Replace the housing cover.
Note
It is recommended the cover be tightened until there is no gap
between the cover and housing.
16
6-1.
March 2020