Safety And System Precautions; Definition Of Safety Symbols; Operational Warnings - Beko DRYPOINT XFi ecoIntelligent Series Installation And Operation Manual

1.

SAFETY AND SYSTEM PRECAUTIONS

1.1 Definition of the Safety Symbols
Before attempting any
service, please read
Risk of damage or injury
the manual
Warning:
Do not operate if parts
Water cannot be used
are missing or have
to extinguish fire
been tampered with
ARIA
AIR
LUFT
AIR
Compressed air inlet connection
1 Experienced and trained personnel familiar with all of the relevant laws, rules and regulations, capable to perform the needed activities and to identify and avoid
possible dangerous situations while handling, installing, using and servicing the machine.
1.2

Operational Warnings

WARNING: VESSELS UNDER PRESSURE

In most countries, states, cities and/or local municipalities the installation, operation and
maintenance of devices where pressure Vessels are in use are subject to local boiler and pressure
Vessel regulations.

The end user is responsible for following all of the relevant laws, rules and regulations and ensuring
that only experienced and trained personnel install and/or operate the dryer.

In most countries, states, cities and/or local municipalities the installation may only be carried out
by a licensed installation company. Inspections must be carried out by a qualified and licensed
third-party firm in accordance with all applicable laws, rules and regulations for the region where
the dryer is installed.

The pressure Vessels used in this device are built according to the American Society of Mechanical
Engineers (ASME) standard Section 8, Division 1.
COMPRESSED AIR WARNING:
Compressed air is a highly dangerous energy source.

Never work on the dryer while components are under pressure.

Never point the compressed air stream or the condensate drain outlet in a direction that may cause
bodily harm.
The end user is responsible for the installation of the dryer as laid out in this manual. If proper
commissioning steps are not followed, the warranty will be void and dangerous situations involving injury
or death and/or damages to the machine could occur.
HOT SURFACE WARNING:
Heated desiccant dryers have hot surfaces that can cause severe burns.

Never touch any component of a heated desiccant dryer without first knowing and confirming the
actual temperature of the surface.
The end user is completely responsible for providing the appropriate protection against any contact with
the dryer.
DRYPOINT XFi 1000 manual_revA EN
Electrical Hazard:
General Warning:
Possibility of
electrocution
Warning:
Warning:
Machine level noise
may exceed 85 dBA
Compressed air outlet connection
Warning:
Warning:
Under
High temperature
pressure
Warning: Warning:
Personal All work to be
protection performed by qualified
required personnel only
Connection point for condensate drain
Warning:
Non-breathable air
Operations that can be
performed by qualified
operators 1
5