Network; General - EverFocus H.265 VANGUARD II Series User Manual

4.4 Network

You can configure the network settings on this page.
4.4.1

General

This page allows you to configure network parameters, such as DHCP, Static IP and PPPoE.
4.4.1.1 General
The DHCP setting lets the system use an automatically assigned (dynamic) IP address. This
address can change under certain circumstances, for instance, when the DVR's network
switch/hub has to be rebooted. DHCP server in LAN will automatically assign an IP
configuration for the network connection.
DHCP: Uncheck the box to set up a Static IP address. Check the box to enable DHCP.
- To set up a Static IP, uncheck the DHCP checkbox and then input the IP Address, Subnet
Mask, Gateway and DNS information.
- To set up a DHCP network, check the DHCP checkbox and the router will automatically
assign all the IP parameters to the DVR. The DHCP setting lets the system use an
automatically assigned (dynamic) IP address. This address can change under certain
circumstances, for instance, when the NVR's network switch/hub has to be rebooted.
DHCP server in LAN will automatically assign an IP configuration for the network
connection.
IP Address: The IP address of the DVR. The IP address consists of four groups of numbers,
separated by periods. For example, "192.168.001.100".
Subnet Mask: Subnet mask is a network parameter which defines a range of IP addresses
that can be used on a network. The subnet address also consists of four groups of numbers,
separated by periods. For example, "255.255.000.000".
76
H.265 VANGUARD II Series