Dremel STYLO+ 2050 Operating/Safety Instructions Manual page 5

ASSEMBLY
ALWAYS UNPLUG ROTARY TOOL
WARNING
!
BEFORE CHANGING ACCESSORIES,
CHANGING COLLETS OR SERVICING
YOUR ROTARY TOOL.
DO NOT ENGAGE LOCK WHILE THE
WARNING
!
ROTARY TOOL IS RUNNING.
BALANCING ACCESSORIES
For precision work, it is important that all accessories be in good
balance (much the same as the tires on your automobile). To true
up or balance an accessory, slightly loosen collet nut and give
1
E
2610Z09886.indd 5
A
D
H
the accessory or collet a 1/4 turn. Re-tighten collet nut and run
the Rotary Tool. You should be able to tell by the sound and feel
if your accessory is running in balance. Continue adjusting in this
fashion until best balance is achieved. To maintain balance on
abrasive wheel points, before each use, with the wheel point se-
cured in the collet, turn on the Rotary Tool and run the 415 Dres-
sing Stone lightly against the revolving wheel point. This removes
high spots and trues up the wheel point for good balance.
B
C
G
5
A. On/Off button
B. Variable Speed Dial
C. Ventilation Openings
D. Shaft Lock Button
E. Collet Nut
F. DC Jack
G. DC Socket
H. Power Adapter
F
1/18/18 7:48 AM