AEG LF8C8412A User Manual page 36

36 www.aeg.com
Problem
The program does
not start.
The appliance fills with
water and drains im-
mediately.
The spin phase does
not operate or the
washing cycle lasts
longer than usual.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise and
vibrates.
The program dura-
tion increases or de-
creases during pro-
gram execution.
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the Start/Pause has been touched.
• If the delay start is set, cancel the setting or wait for the end of
countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected program.
• Make sure that the drain hose is in the correct position. The
hose may be positioned too low. Refer to "Installation instruc-
tion".
• Set the spin program.
• Make sure that the drain filter is not clogged. Clean the filter,
if necessary. Refer to "Care and cleaning".
• Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.
• Make sure that the couplings of the water hoses are tight and
there is not water leakages.
• Make sure that the water inlet hose and the drain hose have
no damages.
• Make sure you use the correct detergent and the correct
quantity of it.
• Too much detergent or unsuitable detergent creates too
much foam. Reduce detergent quantity and/or use a suitable
detergent.
• Make sure that a washing program that ends with water in
tub, has not been selected.
• Make sure that the washing program is finished.
• Set the drain or the spin program if there is water in the
drum.
• Make sure that the appliance receives electrical power.
• This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre.
If you need to open the door, please read carefully "Emer-
gency door opening".
• Make sure the levelling of the appliance is correct. Refer to
"Installation instruction".
• Make sure that the packaging and/or the transit bolts are re-
moved. Refer to "Installation instruction".
• Add more laundry in the drum. The load may be too small.
• The ProSense System is able to adjust the program duration
according to the type and the laundry load size. Refer to
"The ProSense System load detection" in "Daily Use" chap-
ter.