Table of Contents
Advertisement
Tool operators and maintenance personnel must always
comply with the safety precautions given in this manual
and on the stickers and tags attached to the tool and
hose.
These precautions are given for your safety. Review
them carefully before operating the tool and before
performing maintenance.
Supervising
personnel
precautions relating to the specific work area and local
safety regulations. Place the added precautions in the
space provided
The models TP08 Hydraulic Trash Pump will provide
safe and dependable service if operated in accordance
with the instructions given in this manual. Read and
understand this manual and any stickers and tags
attached to the tool and hoses before operation. Failure
to do so could result in personal injury or equipment
damage.
•
Operator must start in a work area without
bystanders. The operator must be familiar with all
prohibited work areas such as excessive slopes and
dangerous terrain conditions.
•
Establish a training program for all operators to
ensure safe operations.
•
Do not operate the tool unless thoroughly trained or
under the supervision of an instructor.
•
Always wear safety equipment such as goggles,
head protection, and safety shoes at all times when
operating the tool.
•
Do not inspect or clean the tool while the hydraulic
power source is connected. Accidental engagement
of the tool can cause serious injury.
•
Do not install or remove this tool while the hydraulic
power source is connected. Accidental engagement
of the tool can cause serious injury.
•
Never operate the tool near energized transmission
lines. Know the location of buried or covered
services before starting work.
•
Do not wear loose fitting clothing when operating the
tool. Loose fitting clothing can become entangled
with the tool and cause serious injury.
•
Supply hoses must have a minimum working
SAFETY PRECAUTIONS
should
develop
additional
pressure rating of 2500 psi/175 bar.
•
Be sure all hose connections are tight.
•
The hydraulic circuit control valve must be in the
"OFF" position when coupling or uncoupling the tool.
Wipe all couplers clean before connecting. Failure
to do so may result in damage to the quick couplers
and cause overheating. Use only lint-free cloths.
•
Do not operate the tool at oil temperatures above
140 °F/60 °C. Operation at higher oil temperatures
can cause operator discomfort and may cause
damage to the tool.
•
Do not operate a damaged, improperly adjusted or
incompletely assembled tool.
•
To avoid personal injury or equipment damage,
all tool repair, maintenance and service must only
be performed by authorized and properly trained
personnel.
•
Do not exceed the rated limits of the tool or use the
tool for applications beyond its design capacity.
•
Always keep critical tool markings, such as labels
and warning stickers, legible.
•
Always replace parts with replacement parts
recommended by STANLEY.
•
Check fastener tightness often and before each use
daily.
•
Do not put your hands or any other body part under
the volute while the trash pump is running.
•
Do not lift the trash pump by pulling on the hydraulic
hoses. Use a suitable line fastened to the trash
pump handle.
•
Do not point water discharge toward bystanders.
TP08 User Manual ◄ 5
Advertisement
Table of Contents
