2.4 Changing Operation Panel Installation Position
4
Remove the screws of the insertion unit.
•
Five hexagonal Phillips socket screws (M4 × 8)
First front side
5
Remove the insertion unit.
Place the removed insertion unit upside down in a level
location where the replacement work can be
performed.
Caution
6
Remove the dummy operation panel.
•
Four tapping screws (M4 × 10)
7
Remove the operation panel cable from the
clamps.
•
Clamps at two locations
2-18
Take out the cables removed in
careful to ensure they are not caught.
step 3
being