Disassembly; Disassembly Flow; Amp Block - Sony SA-WCT800 Service Manual

SA-WCT800
• This set can be disassembled in the order shown below.
2-1.

DISASSEMBLY FLOW

SET

2-2. AMP BLOCK

(Page 6)
2-3. SUB-MAIN BOARD
(Page 7)
2-4. POWER CORD (AC1)
(Page 8)
2-5. SUB-POWER BOARD
(Page 9)
2-6. RF MODULATOR (RF1)
(Page 10)
2-7. SUB-KEY BOARD, BUTTON (POWER-CZ2)
(Page 10)
Note: Follow the disassembly procedure in the numerical order given.
2-2. AMP BLOCK
3 Remove the two cables
from the wiring stopper.
2 Remove the AMP block in
the direction of the arrow.
6
SECTION 2

DISASSEMBLY

2-8. SUB LED BOARD, FRONT PANEL ASSY
(Page 11)
2-9. LOUDSPEAKER (SP1)
(Page 12)
1 ten tapping screws
5 speaker
cable
connector
(CN7202)
4 SUB LED board
cable connector
(CN7405)
6 AMP block
bottom side
JIG
When disassembling the unit, use the following
jig for speaker removal.
Part No. Description
J-2501-238-A JIG FOR SPEAKER REMOVAL
(3.5 16)
speaker cable
rear side
SUB-MAIN board
1 eight tapping screws
(3.5 16)
wiring stopper
top side
Push.
bottom side
SUB LED board cable