Reset Program - Asko T781 User Manual

ning. If condensation water is pumped out di-
rect to the drain, check to ensure there are no
kinks or stoppage in the hose. If this does not
help, phone for service.
Sensor fault. Fault in the moisture sensor. This
error message can also appear if you should start
the dryer when it contains dry items or when it
is empty. To cancel the message, simply open
the dryer door. If this does not work, phone for
service.
Thermistor fault. Phone for service.
WRONG LANGUAGE ON THE DISPLAY
If the language on the display becomes altered
for any reason, it can be restored to the initial
language again.
The available languages are Dansk, Deutsch,
English, Espanol, Français, Italiano, Nederlands,
Norsk, Portugués, Suomi and Svenska.
Proceed as follows to change the language:
Turn the main power switch,
then turn it on again. Press the
times, then press the
These ten times must be completed within fif-
teen seconds.
Within three seconds after pressing
last time, step to the desired language using the
buttons.
, of and
button five
Enter
button five times.
P1
the
P1

RESET PROGRAM

If you wish to revert to the settings which a pre-
set program had at the time when the dryer was
supplied, you can reset the program. Proceed as
follows:
1. Hold down the program button for the pro-
gram that you wish to reset.
2. Press the button once.
Enter
3. Release the program button.
The program for the button is now reset to
its settings when the dryer was supplied.
STOP FLASHES IN THE DISPLAY
Start Stop
The program has stopped temporarily because
the door has been opened, the main power
switch has been turned off or the power supply
has been interrupted.
To restart: Press the
To interrupt the program completely: Press
the button for three seconds.
button.
27