Table of Contents
Advertisement
Problems
1 minute appears in the
display
Water remains in the
machine.
Bad odour in the machine
The dishes are not
sufficiently dry
28
Possible causes
pump) can be heard from the
machine, this does not stop
when the power is switched
off using the main power
switch.
•
The program is taking longer
than estimated.
• Obstruction in the drain
hose.
• Kinks in the drain hose.
• The filters are clogged.
• Items in the drain pump.
• Dirt along the strips and in
corners.
• Drying power too low.
The machine is not fully
loaded.
The rinse aid has run out or
the set dose is too low.
Action
2. Pull out the plug.
3. Call a service engineer
•
No action; next time the
program is run the corrected
time will be displayed.
• Disconnect the drain hose
where it is connected to the
sink's water trap. Check that
no debris has become stuck.
Is the cone-shaped part of
the pipe cut so that the
diameter is at least 16 mm?
• Check that the hose is free
from kinks or sharp bends.
• Clean out the coarse filter,
the fine filter and the filter.
• Clean out the drain pump.
See chapter on cleaning.
• Clean with a dish brush
and low-lather detergent.
• Activate the Normal drying
option (not all models).
Put a full load in the
machine.
Replenish rinse aid or
increase the dose of rinse
aid.
Open the door slightly once
the program has finished.
Advertisement
Table of Contents
