Table of Contents
Advertisement
GENERATOR
MAINTENANCE
The generator warranty does not cover items that have
been subjected to operator abuse or negligence.To receive
full value from the warranty, the operator must maintain
the system as instructed in the engine owner's manual.
All adjustments should be made at least once each season.
Follow the requirements in the engine owner's manual.
Generator maintenance consists of keeping the unit clean
and dry. Operate the unit in an environment where it will
not be exposed to excessive dust, dirt, moisture or any
corrosive vapors. Cooling air louvers on the enclosure
must not become clogged with snow, leaves, or any other
foreign material.
Check the cleanliness of the unit frequently and clean when
dust, dirt, oil, moisture or other foreign substances are
visible on its exterior surface.
NOTE: Do Not use direct spray from a garden hose to
clean generator.Water can enter the engine and cause
problems. In addition, if water enters the generator through
cooling air slots, some water will be retained in voids and
cracks may develop in the rotor and stator winding
insulation.Water and dirt buildup on the generator internal
windings will eventually decrease the insulation resistance
of these windings.
Changing Engine Oil
•
Place the oil drain tube into an approved container.
•
Push in and rotate the oil drain fitting 1/4 turn
counterclockwise. Slowly pull outward until oil starts
draining (Figure 6). DO NOT pull the oil drain fitting off
the engine.
Figure 6 — Oil Drain Fitting
•
When the oil has drained, push the oil drain fitting in
and rotate 1/4 turn clockwise until it locks in place.
Briggs & Stratton Power Products Home Generator System
Owners Manual
18
•
Slide the oil drain tube up into the clamp on the
generator.
CAUTION!
Any attempt to crank or start the engine
before it has been properly filled with the recommended oil
will result in engine failure.
To fill your engine with oil:
•
Follow the synthetic oil grade recommendation and oil
fill instructions given in the engine owner's manual.
To Clean the Generator
CAUTION!
NEVER insert any object or tool
through the air cooling slots, even if the engine is
not running.
• Use a damp cloth to wipe exterior surfaces clean.
• A soft, bristle brush may be used to loosen caked on
dirt, oil, etc.
• A vacuum cleaner may be used to pick up loose dirt and
debris.
• Low pressure air (not to exceed 25 psi) may be used to
blow away dirt. Inspect cooling air slots and openings on
the generator.These openings must be kept clean and
unobstructed.
If You Call the Factory
You must have the following information at hand if it is
necessary to contact Briggs and Stratton Technical Services
regarding service or repair of this unit:
1.
Obtain the unit Model Number and Serial Number
from the unit data decal. See "Know Your Backup
Generator" diagram for location.
2.
Obtain the engine Model/Type/Code numbers from the
engine label. See "Know Your Backup Generator"
diagram for location. Please note that the model
number may vary slightly from that presented herein.
STORAGE
The Briggs & Stratton Home Generator System is designed
for continuous backup operational duty. As such, there is no
need to take any storage precautions. However, if it
becomes necessary to take the system out of service for
an extended period, call Briggs and Stratton Technical
Services at 1-800-743-4115, between 8:00 AM and 5:00 PM
CT for specific recommendations.
Hide quick links:
Advertisement
Chapters
Table of Contents
