Table of Contents
Advertisement
70
Setting IP Address and Port Filtering
Set whether to apply rules and allow transmissions from Internet through firewall, based on sender/receiver addresses.
Settable items are the following.
Item
Source IP Address
Source Port Range
Dest. IP Address
Dest. Port Range
Protocol
Status
IP Settings
Options
Settings tab
Device
・See
"Firewall
Settings" and enable firewall before making settings.
Set source IP address to apply rules; specify IP address from IP addresses used on LAN. Use
wildcard. "any" or empty address cannot be set.
Set source port number to apply rules.
If protocol set to
Empty address cannot be set as port range.
Set destination IP address to apply rules.
Use wildcard. "any" or empty address cannot be set.
Set destination port number to apply rules.
If protocol set to
Empty address cannot be set as port range.
Select protocol to apply rules.
Set whether to apply rules.
Make IPv4/IPv6 settings.
Save, edit, or delete rules.
Firewall
Description
TCP
/
UDP
, specify lowest and highest values.
TCP
/
UDP
, specify lowest and highest values.
Advertisement
Table of Contents
