Invacare Action 2 Basic Service Manual page 15

SECTION 3—ARMRESTS
Installing Swing Away Armrest
1. If necessary, remove existing armrest assembly as describe above
2. Install new/existing armrest assembly, first into the rear pivot socket and
into the front arm socket.
3. Lock new/existing armrest assembly by operate the push pin
Make sure that the dog point is properly engaged in its housing.
4. Repeat STEPS 1
Dog point
Ac t i on ² Ba s i c
3 for opposite side, if necessary.
-
FIGURE 3.2
Removing/Installing Swing Away Armrest
1 5
.
.
Push pin
Rear pivot
socket