Tuning In To A Preset Station - JVC FS-H35 Instructions Manual

To preset stations manually—Manual presetting
You need to preset stations separately for the FM and
AM bands.
• There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step 2 .
On the remote control ONLY:
1
Tune in to the station you want to
preset.
• See "Tuning in to a Station" on page 12.
2
Press SET.
3
Press UP or
to select a preset number.
4
Press SET again.
The tuned station in step 1 is stored in the preset
number selected in step 3 .
• Storing a new station on a used number erases
the previously stored one.
When you unplug the power cord or if a power
failure occurs
The tuner preset stations will be erased in a few days. If this
happens, preset the stations again.

Tuning in to a Preset Station

On the remote control ONLY:
1
Press TUNER to select the
band.
The unit automatically turns on
and tunes in to the previously
received station—either FM or AM.
• Each time you press the button, the band
alternates between FM and AM.
2
Press UP or
to select a preset number.
13
EN01-13_FS-H30[C]f.pm6
SET
UP
DOWN
DOWN
TUNER
UP
DOWN
DOWN
13
To tune in to a preset station directly using the
number buttons
On the remote control ONLY:
Pressing the number button(s)
allows you to select the preset
number you want.
Ex.: For preset number 5, press 5.
For preset number 15, press
+10, then 5.
For preset number 20, press
+10, then 10.
For preset number 30, press
+10, +10, then 10.
03.2.5, 6:43 PM
1 2 3
4 5 6
7 8 9
10 10