Table of Contents
Advertisement
6. Disconnect the cables that are connected to the drive backplane.
Steps
1. Using Phillips #2 screwdriver, loosen the two captive screws on the drive backplane.
2. Holding the edges, lift the backplane away from the sled.
Figure 33. Removing the drive backplane
Next steps
1.
Install the drive
backplane.
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Align the hooks and captive screws on the drive backplane with the slots and screw holes on the sled.
2. Lower the drive backplane until it seat into place.
3. Using a Phillips #2 screwdriver, tighten the two captive screws to secure the drive backplane to the sled.
Safety instructions
Before working inside your sled
section.
section.
Installing and removing sled components
37
Advertisement
Table of Contents
