Table of Contents
Advertisement
4 Press the REC button to begin recording.
• The tally lamp changes from green (power indicator) to red.
• [S&F STBY] changes to [S&F ÜREC] while recording.
5 Press the REC button again to stop recording.
• The clip is recorded on the selected SD card.
• When [S&F Clip/Audio (WAV)] is selected, audio in WAV format will be recorded on the SD card where video
is not being recorded.
• The tally lamp changes from red to green (power indicator) and the onscreen display changes back to [S&F
STBY].
6 Select
> [Æ Recording/Media Setup] > [Recording Mode] > [Normal Recording] to turn off
slow & fast motion recording.
NOTES
NOTES
• The shooting frame rate cannot be changed while recording.
• If you change the system frequency, slow & fast motion recording will be canceled and the shooting frame rate
will be reset to its default value.
• About the time code when slow & fast motion recording is activated:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.
- If the time code running mode was set to [Free Run], the time code running mode will be changed
automatically to [Rec Run] when slow & fast motion recording is activated.
- When the special recording mode is turned off, the time code running mode will return to its previous setting.
- The time code signal will not be output from any terminal.
• Recording Audio (WAV)
- Audio is recorded with the following settings: 48 kHz, 24 bit, 4 channels.
- If video cannot be recorded due to a card problem, audio will also not be recorded.
- However, video will be recorded even if audio cannot be recorded due to a card problem.
- Audio will not be recorded if there is an existing WAV file with the same file name.
- Audio recording will stop automatically after reaching 60 minutes (video recording will continue).
- A maximum of 999 WAV files can be recorded.
Pre-recording
When pre-recording is activated, the camera starts recording continuously onto a temporary memory (approx.
3 seconds) so when you press the REC button, the clip will contain also a few seconds of video and audio
recorded before you pressed the button.
1 Select
> [Æ Recording/Media Setup] > [Recording Mode] > [Pre-Recording].
• [PRE STBY] appears on the screen.
• You can also use direct touch control (A 49).
2 Press the REC button to begin recording.
• The tally lamp changes from green (power indicator) to red.
• [PRE STBY] changes to [PRE ÜREC] while recording.
3 Press the REC button again to stop recording.
• The clip is recorded. The recorded clip will include a few seconds of video and audio recorded before the
REC button was pressed.
• The tally lamp changes from red to green (power indicator) and the onscreen display changes back to [PRE
STBY].
Special Recording Modes
101
Advertisement
Table of Contents
