Stiga ZT 5132 T Workshop Manual page 22

WORKSHOP MANUAL
ZT 5132 T
B) Adjusting the "neutral" position
1. Remove the guard (1) fixed by the screws (2)
and (3).
2. Release the split pin (4) and washer (5) and
disconnect the parking brake rod (6).
3. Remove the starter cable (7) from the control
lever.
4. Start the engine and take the accelerator to
maximum speed.
5. Check the axle rotation. If the axle does not ro-
tate, proceed to Step 6. If the axle does rotate,
proceed to Step 7.
6. Stop the engine and reconnect the rod (7) and
adjust the mechanical linkage of the machine.
7. Observe the direction of the axle rotation.
Switch the engine off. Loosen the adjuster
screw (8) so that it is possible to rotate the con-
trol arm (9). Rotate the control arm in the op-
posite direction to the axle rotation with small
5° increases until the axle comes to a halt.
8. Tighten the adjuster screw (8) to a torque of 20
Nm. Repeat the control as specified in steps 4
and 5.
9. Engage and disengage the parking brake and
make sure that the pin (10) enters the slot cor-
rectly (11); if this is not the case, follow the in-
structions indicated in paragraph b).
5 - STEERING SYSTEM - TRANSMISSION - WHEELS
Chapter
3
6
7
9
10
11
EDITION PAGE
2017 22 /
58
2
1
4
5
8