Table of Contents
Advertisement
Setup Options
The following options are available under the Setup Options submenu:
Software Version
The Software Version Screen provides the following information:
Use the following steps to check the software version information for the Octaire Control Panel.
To check the software version information:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Setup Options by scrolling with the Control Dial.
3.
Press the Select Key.
The Setup Options submenu appears.
Locate Software Version by scrolling with the Control Dial.
Press the Select Key again to choose Software Version.
The Software Version Screen appears.
Octaire Instruction Manual
Software Version
– to display software version information for the Control Panel
Default VM
– to change the factory default virtual matrix (routing level)
Reload Config
– is not used in normal operations; use only when directed to do so by
technical support
VIS Config
– to enable or disable Vertical Interval Sync
Change Password
– to change the password from the factory default
Driver
– Control Panel's firmware version
Built
– date the Control Panel's software was built
Host
– software version of the initial operating system (IOS) for the Control Panel
XNet ID
– Control Panel's XNNet device number
Octaire Control Panel Operation
Version number
59
Advertisement
Table of Contents
