Table of Contents
Advertisement
electronic devices inside the key, it
should never be exposed to direct
sunlight.
IMPORTANT
1) Remote control used batteries may
be harmful to the environment if not
disposed of correctly. They must be
disposed of as specified by law in the
special containers or taken to a Jeep
Dealership, which will take care of their
disposal.
IGNITION DEVICE
2) 3) 4) 5)
VERSIONS WITH MECHANICAL
KEY
The key can be turned to three different
positions fig. 6:
STOP: engine off, key can be removed,
steering column locked (with key
removed). Some electrical devices (e.g.
central door locking system, alarm, etc.)
are still available;
MAR: driving position. All electrical
devices are available;
AVV: engine starting.
6
NOTE On versions with automatic
transmission the ignition key can only
be removed when the gear lever is at P
(Park).
VERSIONS WITH ELECTRONIC KEY ("Keyless
Enter-N-Go" system)
To activate the ignition device the
electronic key must be inside the
passenger compartment. The ignition
device fig. 7 activates also if the
electronic key is inside the boot or on the
rear shelf.
7
The ignition device has the following
J0A0021C
possible states:
STOP: engine off, steering column
locked. Some electrical devices (e.g.
central door locking system, alarm, etc.)
are still available;
MAR: driving position. All electrical
devices are available. This state can
be entered by pressing the ignition
device button once, without pressing the
brake pedal (versions with automatic
transmission) or the clutch pedal
(versions with manual gearbox);
AVV: engine starting.
Starting the engine (with electronic key
battery flat): in this case, rest the
rounded edge of the electronic key (the
side opposite the metal insert) on the
J0A0022C
15
Advertisement
Table of Contents
