Table of Contents
Advertisement
FOUR WHEEL DRIVE-
JEEP ACTIVE DRIVE
(4WD) and JEEP ACTIVE
DRIVE LOW (4WD LOW)
FOUR-WHEEL DRIVE
The four wheel drive (4WD) is fully
automatic in standard driving mode.
WARNING Changing mode is not
possible when the vehicle speed is over
120 km/h.
Four-wheel-drive activation
42) 43)
The buttons to activate the four-wheel
drive are located on the Selec-Terrain™
device and can select:
4WD LOCK (fig. 104 versions
with manual gearbox and automatic
transmission): deactivates the function
for disconnecting the propeller shaft,
guaranteeing the immediate availability
of the torque to the rear coupling. This
function can be selected in AUTO mode
and is automatic in the other driving
modes.
138
104
4WD LOW (fig. 105 versions with
automatic transmission): it enhances the
"off-road" performance of the car in all
driving modes;
105
The 4WD LOCK function can be
activated by pressing the dedicated
button or when the selector is rotated
from AUTO to SNOW/SAND/MUD or
ROCK (Trailhawk versions) and 4WD
LOW was not selected before.
The engagement of one function (e.g.
4WD LOW) deactivates the other one
automatically.
WARNING On some versions, pressing
the button 4WD LOW the 4WD LOCK
function is automatically activated as
well. If the 4WD LOW button is pressed
again, the 4WD LOCK function will be
J0A0908C
activated. If, however, the 4WD LOCK
button is pressed again, both functions
will be deactivated.
WARNING The 4WD LOW function is
recommended for irregular and slippery
terrain only.
4WD LOW MODE
ENGAGEMENT/RELEASE
4WD LOW mode engagement
With vehicle at a standstill, starter
switch in MAR position or with engine
on, move the gear lever to position D
(Drive), R (Reverse) or N (Neutral) and
press the 4WD LOW button.
J0A0909Ch
On some versions, with mode engaged,
the display shows "4WD LOW". The LED
on the Selec-Terrain™ device may flash
until the end of the engagement.
Advertisement
Table of Contents
