AMX Modero NXD-1200V Operation/Reference Manual page 13

1200V Panel Specifications (Cont.)
Button Assignments:
Front Panel Components:
Light sensor:
Motion sensor (PIR):
Front setup access button:
Microphone:
Speakers:
Rear Panel Components:
Audio/Video connector:
Ethernet 10/100 port:
Ethernet 10/100 LEDs:
PWR connector:
1200V Modero Video Touch Panels
Button assignments can only be adjusted in TPD4 and not on the panels.
• Button channel range: 1 - 4000 button push and Feedback (per address
port)
• Button variable text range: 1 - 4000 (per address port)
• Button states range: 1 - 256 (General Button; 1 = Off State, 2 = On State)
• Level range: 1 - 600 (default level value 0-255, can be set up to 1-65535)
• Address port range: 1 - 100
• Photosensitive light detector for automatic adjustment of the panel
brightness (a dim room results in a dimmer LCD display and a bright
room results in a brighter LCD display).
Note: The light sensor can be adjusted via the Sensor Setup Page section
on page 110.
• Proximity Infrared Detector to wake the panel when the panel is
approached.
• Activation range: + 20° vertically from center and + 45° horizontally
from center.
Note: The motion sensor can be adjusted via the Sensor Setup page
(Sensor Setup Page section on page 110).
• Provides both access to the Setup and Calibration pages and toggles the
panel between a "sleep" and "wake" state.
- When wired, "sleep" status means the backlight is Off.
- When battery operated, wireless "sleep" status means the touch panel
base is either Off or "suspended".
• Used for intercom applications
(requires an NXA-AVB/ETHERNET Breakout Box for analog
communication).
• Stereo output with a frequency response of 450 Hz - 7 KHz
(Side panel location on NXD-Wall Mount panels)
• RJ-45 connector for communication of differential audio/video signals
to/from the touch panel (panel type dependant). This connector receives
Composite video, Stereo (left/right) audio, and microphone audio.
• Video is received via the NXA-AVB/ETHERNET Breakout Box.
Configuring video windows for playback is done using TPDesign4.
• In-bound audio (from the breakout box) gets directed to the speakers.
• Out-bound audio is sent from the on-board microphone (on the
front-panel). Selecting audio files for playback is configured through
TPDesign4.
• RJ-45 port for 10/100 Mbps communication. The Ethernet port
automatically negotiates the connection speed (10 Mbps or 100 Mbps),
and whether to use half duplex or full duplex mode.
• These panels communicate with the NetLinx
protocol over Ethernet.
• LEDs show communication activity and connection information:
A-activity - Yellow LED lights when receiving or transmitting Ethernet
data packets.
L-link - Green LED lights when the Ethernet cables are connected and
terminated correctly.
• 2-pin 3.5 mm mini-Phoenix connector.
Introduction
®
Master using the ICSP
3