Operating Instructions; Battery; Tool Settings - Stanley SB25PT-05 Instruction Manual

4. OPERATING INSTRUCTIONS

ALWAYS wear approved hearing and eye protection at all times when using
installation equipment
WARNING: Before adjusting tool, always remove the battery pack.

4.1 BATTERY

4.1.1 TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE (FIG. F)
• Align the battery pack (g) with the rails inside the tool's handle.
• Slide it into the handle until the battery pack is fi rmly seated in the tool and ensure that you hear the
lock snap into place
4.1.2 TO REMOVE THE BATTERY PACK FROM THE TOOL (FIG. F)
• Press the release button (h) and fi rmly pull the battery pack out of the tool handle.
• Insert the battery into the charger as described in Fig. G.

4.2 TOOL SETTINGS

4.2.1 MODE SELECTION (FIG. B-D)
Your tool features a mode selector to select the operation required. Rotate lightly by hand to select the
mode required.
Fig B. – Placing mode
• Use this mode only when loaded mandrel, cursor and correct nose jaws are fi tted to the tool.
• Tail jaws cannot be removed in this mode unless the mandrel is removed
Fig C. – Locked mode
• Specifi cally designed for safety purposes. Pulling the trigger will not function the tool.
• Use this mode for when tool is travelling or when not in use.
Fig. D. – Reload mode
• Allows user to remove and replace the mandrel
• The trigger behavior for this mode differs from placing mode
4.2.2 TRIGGER
Fig. A - The trigger (a) has three (3) different modes.
Mode
Placing Option one: Hold the trigger down for the duration of the cycle. The trigger has a failsafe to
prevent over-stroking of the tool meaning it will return automatically to home position after
full stroke is achieved
Option two: Hold the trigger down and release as soon as the fastener is placed. The tool
will revert back to the home position automatically.
Locked Squeezing the trigger will not function the tool. There is a 1 second time delay preventing any
further actuation of the tool in this mode.
Reload Hold trigger down for >1s, the tool will move to force open the jaws. The work light will fl ash
once a second for up to two minutes. To revert the tool back to home after reloading, hold
the trigger down for >1s. the work light will stop fl ashing.
NOTE: the trigger may not actuate immediately after reaching home position. Ensure the work light is off
prior to actuating the trigger again. This is applicable for all tool modes.
ORI GI N A L I N S T RU C T I O N
15