Installation Of Indoor Unit; Conditions Where Indoor Unit Is Installed - LG THERMA V HN0916T Installation Manual

INSTALLATION OF INDOOR UNIT

The indoor unit of
and refrigerant pipe from the outdoor unit are accessible at the same time.
In this chapter conditions for installation place is described. In addition, considerations when
installing accessories or 3rd party accessories are described, too.

Conditions where Indoor Unit is Installed

Specific conditions are required for installation place such as service space, condensate
drainage, water pipe length and height, total volume of water, adjusting expansion vessel, and
water quality.
General Considerations
Followings are should be considered before the installation of the indoor unit.
- The installation place should be free from outdoor weather conditions such as rain, snow, wind,
frost, etc.
- Choose the place where is water-resistant or good drainage.
- Service space should be secured.
- No flammable materials around the indoor unit.
- Mice can not be appeared to prevent entering the indoor unit or attacking wires.
- Do not place anything in front of the indoor unit to ensure air circulation around the indoor unit.
- Do not locate anything under the indoor unit to be free from unexpected water out.
- In case of water pressure increasing to 3 bar or tank pressure increasing to 10 bar, water
drainage should be treated when water is drained by safety valve.
WARNING
!
Do not block the venting openings on the backside of the unit!
CAUTION
!
The device must not be installed under pipelines because there is a possibility of condensate
forming. Ingress of water condensate can cause disturbances in the operation.
NOTICE
The installation location of the indoor unit must be dry and in the temperature range between
+10 ˚C and 40 ˚C, for a short period (up to 24h) also up to 55 °C.
is installed inside where terminal of under floor water pipe cycle
INSTALLATION OF INDOOR UNIT
33