Adjusting The Height Of Cut - Toro Z Master 4000 Series Operator's Manual

Adjusting the Height of Cut

For Machines with a Deck-Lift
Pedal
Using the Transport Lock
1. Push the deck-lift pedal fully forward to lock the
mower deck in the T
29).
2. Push the deck-lift pedal forward and push the
transport lock forward to the U
then slowly lower the mower deck.
Figure 29
1. L position—the
OCK
mower deck locks into
the transport position.
2. U position—the
NLOCK
mower deck does not lock
into the transport position.
position (Figure
RANSPORT
position,
NLOCK
(Figure
3. Push on the deck-lift pedal
using your foot to raise the
mower deck.
Adjusting the Height-of-Cut Pin
You can adjust the height of cut from 38 to 140 mm
(1-1/2 to 5-1/2 inches) in 6 mm (1/4 inch) increments
by relocating the clevis pin into different hole locations.
1. Push the deck-lift pedal fully forward to lock the
mower deck in the T
140 mm/5-1/2 inches cutting height position) as
shown in
2. To adjust, remove the pin from the height-of-cut
bracket
3. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
29).
insert the pin
4. Push the deck-lift pedal forward, push the
transport lock forward, and slowly lower the
mower deck.
g332768
1. Deck-lift pedal
2. Height-of-cut bracket
29
RANSPORT
Figure 30.
(Figure 30).
(Figure 30).
Figure 30
3. Height-of-cut pin
4. Transport-lock lever
position (also the
g332767