Operating The Mower Blade-Control Switch (Pto); Operating The Throttle; Operating The Choke - Toro Z Master 4000 Series Operator's Manual

Operating the Mower
Blade-Control Switch (PTO)
The blade-control switch (PTO) starts and stops the
mower blades and any powered attachments.
Engaging the Blade-Control
Switch (PTO)
Note:
Engaging the blade-control switch (PTO) with
the throttle position at half or less causes excessive
wear to the drive belts.
Figure 20
Disengaging the Blade-Control
Switch (PTO)
Figure 21

Operating the Throttle

You can move the throttle control between F
S positions
LOW
Always use the F

Operating the Choke

Use the choke to start a cold engine.
1. Pull up the choke knob to engage the choke
before using the key switch
g332523
2. Push down the choke knob to disengage the
choke after the engine has started
g332522
1. O position
N
25
(Figure 22).
position when engaging the PTO.
AST
Figure 22
(Figure
Figure 23
2. O position
FF
and
AST
g008946
23).
(Figure 23).
g008959