Toro Z Master 4000 Series Operator's Manual page 68

9. For 60-inch mower decks only:
A. Raise the deck to the transport position
(140 mm or 5-1/2 inches).
B. Slowly loosen the adjusting screw on the
lift-assist spring until you can remove the
screw (Figure
Note:
Save the screw for installation.
1. Adjusting screw
2. Bracket
10. Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
99).
11. Set the height-of-cut lever to the 76 mm (3
inches) position.
12. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
98).
Figure 98
3. Set the gap to 22 to 29
mm (7/8 to 1-1/8 inches).
1. Block—73 mm (2-7/8
inches)
Block Height and Rake Table
Deck
Size
All mower
decks
13. Carefully rotate the blades side to side
96).
14. Loosen the locknuts
corners and ensure that the mower deck is
sitting securely on all 4 blocks.
g334850
15. Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
16. Tighten the 4 lock nuts.
(Figure
1. Locknuts
2. Deck lift arm
68
Figure 99
Bottom view
2. Welds
Front Block Height Rake
73 mm (2-7/8 inches) 4.8 to 6.4 mm (3/16 to 1/4
inch)
(Figure
Figure 100
3. Deck hanger
4. Chain
g038090
(Figure
100) on all 4
g035851