Table of Contents
Advertisement
Step 9 Connect I/O,
Attach IDE Cable to JP5 JP5 is the primary IDE (Integrated Drive
MegaRUM II PCI Motherboard User's Guide
28
Continued
Electronics) hard disk drive connector. Both the primary
master and the primary slave IDE drives must be
connected by cable to JP5, as shown below.
JP5 is a 40-pin dual-inline berg that connects an IDE
drive to the primary onboard IDE connector. This
motherboard supports IDE Modes 0, 1, 2, 3, and 4, IDE
prefetch, LBA (Logical Block Address) mode, high
capacity drives (over 528 MB), 32-bit data transfer, and
fast IDE transfer. These IDE features are configured in
Peripheral Setup in the AMIBIOS Setup utility.
Disable the onboard IDE interface in Peripheral Setup to
use an ISA ESDI, RLL, MFM, or SCSI hard disk drive
controller.
Cont'd
Advertisement
Table of Contents
