Table of Contents
Advertisement
Programming the Flash ROM,
Beep Codes
The bootblock code produces a series of beeps during Flash ROM
programming to:
signify completion of a step (as shown on the previous screen), or to
signal an error.
Error beeps are arranged in a coded sequence and have different meanings
depending on when they occur. The error beep codes and when they can occur
are:
Number of Beeps
1
Insert diskette in floppy drive A:.
2
The AMIBOOT.ROM file was not found in the root directory of the diskette
in floppy drive A:.
3
Base memory error.
4
Flash program successful.
5
Floppy read error.
6
Keyboard controller BAT command failed.
7
No Flash EPROM detected.
8
Floppy controller failure.
9
Boot Block BIOS checksum error.
10
Flash erase error.
11
Flash program error.
12
AMIBOOT.ROM file size error.
Continuous beep
Flash Programming successful. Turn power off. The turn power on again to
restart.
Chapter 2 WINBIOS Setup
Continued
Description
67
Advertisement
Table of Contents
