Extron electronics ShareLink Pro 500 User Manual page 25

1 Device Info — Use this panel to change the device hostname. Click Edit to enter a
new hostname, and click Save.
2 Device Status — Click Edit to change the device time, date, and time zone. Click
Sync to PC to automatically sync the device to the PC time zone.
3
Firmware — Use this panel to update the device firmware:
1. Click Select File to browse to the firmware file.
NOTE: The latest firmware file can be downloaded from the Extron website (see
Firmware Download
2.
Select the firmware file, and click Update.
4 Network Settings — Click Edit to change the device name and the network settings
(IP address, subnet, and gateway IP address) for the LAN port.
5 Roles and Permissions — Click Edit to change the following passwords:
NOTE: The factory configured password for all accounts have been set to the
device serial number. Passwords are case sensitive. Performing a
Factory Defaults
Admin password (default: extron) — This password is used for accessing the
•
admin page.
Moderator password (default: moderate) — This password is required to
•
moderate a session.
Participant password (default: no password) — This password is required to
•
participate in a session.
Enter and confirm the new password, and click Save.
6 LinkLicense — Use this panel to upload the LinkLicense file to the
ShareLink Pro 500. If a LinkLicense has been purchased, upload the file as follows:
a. Click Select File and browse to the LinkLicense (.ell) file on your computer.
b. Select the file, and click Add to upload the file.
on page 48).
(see page 7) sets the password to the defaults shown below.
ShareLink Pro 500 • Operation Using a Computer
Reset to
18