Operation - Manual Switch - IOGear GUB231 User Manual

Operation – Manual Switch
Note: Software installation is not mandatory for
the USB 2.0 Peripheral Sharing Switch to function.
The device supports manual operation. Manual
operation and software-based operation operate
independently; commands from one will not
override the other.
For GUB231:
To switch the connection to the USB device
between the two computers, press the port
selection button located on the top center of
the Sharing Switch. The selected port LED will
flash and the Sharing Switch will beep. After four
seconds, the flashing will stop and the LED will
become steady, the port switch is completed
successfully.
For GUB431:
To switch the connection to the USB device
between the four computers, press the
corresponding port button located on the top of
the Sharing Switch. The selected port button LED
will flash and the Sharing Switch will beep. After
four seconds, the flashing will stop and the LED
will become steady, then port switch is completed
successfully.
12