raised far enough to access the blade screw
guard will remain raised due to the position of the
guard bracket screw.
4. Depress the spindle lock button
rotating the saw blade
26
lock engages.
5. Keeping the button depressed, use the other hand and
the 1/4" hex side of the wrench
the blade screw
24
. (Turn clockwise, left-hand threads.)
6. Remove the blade screw
the wrench provided, the outer clamp washer
blade
. The inner clamp washer
26
the spindle
29
.
Installing a Blade (Fig. A, E–G)
1. Remove battery pack
13
2. With the arm raised, the lower guard
the guard bracket
raised, place the blade
23
the spindle
29
and against the inner clamp washer
with the teeth on the blade pointing in the direction of
rotation as marked on the saw.
3. Assemble the outer clamp washer
spindle
29
.
4. Install the blade screw
24
lock button
, tighten the blade screw
25
with wrench
18
provided (turn counterclockwise, left-
hand threads).
5. Return the guard bracket
position and firmly tighten the guard bracket screw
to hold bracket in place.
WARNING: The guard bracket must be returned
to its original full down position and the guard
bracket screw tightened before activating the
saw. Failure to do so may prevent the guard
from closing or may allow the guard to contact
the spinning saw blade resulting in damage to
the saw and severe personal injury.
Fig. E
24
. Lower
25
while carefully
by hand until the
18
provided to loosen
24
using the 1/4" hex side of
27
and
may be left on
28
from the saw.
4
held open and
on
26
28
27
onto the
and, engaging the spindle
firmly
24
23
to its original full down
21
21
23
27
24
26
Fig. F
Fig. G
27
24
Transporting the Saw (Fig. A)
WARNING: To reduce the risk of serious personal
injury, turn tool off and remove the battery pack
before transporting, making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal
injury, ALWAYS lock the rail lock knob, miter lock
handle, bevel lock handle and lock down pin, and
remove the battery before transporting saw.
In order to conveniently carry the miter saw from place
to place, hand indentations
8
base, as shown in Figure A. Do not lift or carry by the
operating handle
2
.
FEATURES AND CONTROLS
WARNING: To reduce the risk of serious personal
injury, turn tool off and remove the battery pack
before transporting, making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
English
25
26
29
28
have been placed in the
11