Product Specifications, Unpacking, And Accessories; Features - Craftsman 315.114260 Operator's Manual

TRIM SAW
Blade Diameter
Blade Arbor
Cutting Depth at 0°
Cutting Depth at 45°
No load Speed
Motor
Your trim saw has been shipped completely assembled
except for the blade. Inspect it carefully to make sure no
breakage or damage has occurred during shipping. If any
parts are damaged or missing, contact your nearest Sears
Retail Store to obtain replacement parts before attempting
to operate saw. A blade, blade wrench (5 mm hex key), rip
guide (edge guide) and this operator's manual are also
included.
The following recommended accessories are currently available at Sears Retail Stores.
5-1/2 in. Thin Kerf Blade
WARNING:
The use of attachments or accessories not listed might be hazardous.
KNOW YOUR TRIM SAW
See Figure 1.
Before attempting to use your trim saw, familiarize yourself
with all operating features and safety requirements.
Features include easily operated bevel cut and depth of
cut adjustment mechanisms; positive 0° bevel stop;
spindle lock; and blade wrench storage.
WARNING:
Do not allow familiarity with your
saw to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
PRODUCT SPECIFICATIONS
315.114260
5-1/2 in.
3/8 in.
1-9/16 in.
1-1/8 in.
4,500 RPM
19.2 Volt DC
UNPACKING
ACCESSORIES

FEATURES

CHARGER
Input
Charging Voltage
Charge Rate
BATTERY PACK
WARNING:
If any parts are missing, do not
operate your saw until the missing parts are replaced.
Failure to do so could result in possible serious per-
sonal injury.
SWITCH
Your saw is equipped with a lock-off button which reduces
the possibility of accidental starting. The lock-off button is
located on the handle above the switch trigger. You must
depress the lock-off button in order to pull the switch
trigger. The lock resets each time the trigger is released.
Note: You can depress the lock-off button from either the
left or right side.
APPLICATIONS
(Use only for the purposes listed below)
Cutting all types of wood products (lumber, plywood,
paneling).
8
ITEM NO. 11041
9
(1425301)
120 V, 60 Hz, AC only
19.2 Volt
1 Hours
ITEM NO. 11375
9
(1323517 and 1323903)