Table of Contents
Advertisement
■Installation
●Installation of the amplifier unit
Perform offset adjustment before the installation of the amplifier unit. Refer to page 17.
○Direct installation
For direct mounting, use M3 screws (2 pcs.) or equivalent.
The recommended tightening torque of the screw is 0.5 to 0.7 Nm.
Mount the product on a flat and even surface. Mounting on an uneven surface can damage the case.
Screws and washers should be supplied by the user.
○Installation using DIN rail
Mounting
(1) Hook the claw part 1 to the DIN rail (35 mm width).
(2) Push the claw part 2 down until it clicks.
Removal
(1) Push the body towards the Sensor socket end.
(2) Pull the Sensor socket end upwards.
: We recommend using an end plate when mounting onto DIN rail. Refer to DIN rail end plate manufacturers for further details.
-18-
No.D-※S-OMG0006-C
Advertisement
Table of Contents
