Lochinvar Armor AWH0400N Installation & Operation Manual page 62

11
Start-up
Configuration of the cascade
NOTE: For more detailed instructions, please refer to the
Armor Service Manual.
When installing a Cascade system, all units must be
programmed for Cascade to operate. Access the Cascade
Setup options as follows:
1. Press the SETUP button on the left side of the display
screen.
2. Enter the installer password.
3. Select the Cascade option as shown in FIG. 11-5.
4. Each unit must have a unique address set. The leader has
more options which are described in the Armor Service
Manual.
5. Once all the updates are complete, press the Door Menu
slider (top left) or the Setup button.
6. Press the APPLY CHANGES button on the top of the
screen.
Figure 11-5 Cascade Screen
62
Installation & Operation Manual
NOTE: The APPLY CHANGES button must be pressed to
complete programming of the controls. Failure to press the
APPLY CHANGES button will result in an unprogrammed
control. The Door Menu button will become highlighted when
there are changes that can be applied.