Safety Information - Pitney Bowes SendPro Mailstation User Manual

Safety information

To avoid personal injury or damage to the equipment, familiarize yourself with proper procedures
l
and methods before you install, operate, or repair the system.
Follow these safety precautions whenever you use your meter.
l
Use the equipment only for its intended purpose.
l
Always follow the specific occupational safety and health standards prescribed for your workplace.
l
Place the meter close to an easily accessible wall outlet. DO NOT use a wall outlet controlled by a
l
wall switch or one that is shared with other equipment.
Be certain the area in front of the wall receptacle into which the meter is plugged is free from
l
obstruction.
Place the system in an accessible location to allow for proper venting of the equipment and to
l
facilitate servicing.
Use the AC power cord included with the meter.
l
Plug the AC power cord directly into a wall outlet located near the equipment and easily
l
accessible.
The AC power cord is the primary means to disconnect this device from the AC power supply.
l
DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make sure
l
there is no strain on the power cord.
Always unplug the system and discharge static electricity before using aerosol dusters.
l
Use only Pitney Bowes-approved supplies, in particular aerosol dusters. Improper storage and
l
use of aerosol dusters or flammable aerosol dusters can cause an explosive-like condition that
could result in personal injury, property damage, or both. Never use aerosol dusters labeled
flammable and always read instructions and safety precautions on the duster label.
If the unit becomes damaged, unplug is from the wall.
l
Keep fingers, long hair, jewelry and loose clothing away from moving parts at all times.
l
Always follow specific occupational safety and health standards for your workplace.
l
DO NOT remove covers. The covers enclose hazardous parts that should only be accessed by
l
properly trained service personnel.
DO NOT run the system with the top cover open. Running the system with the top cover open
l
increases the risk of entanglement with moving parts.
DO NOT place lighted candles, cigarettes, cigars, etc., on the system.
l
Contact your system supplier for
l
Supplies
o
Material Safety Data Sheets
o
If you damage the unit
o
The device is not intended for use in the immediate field of vision at the workstation. To avoid
l
disturbing reflections at the workstation, this product must not be placed in the immediate field of
view.
Pitney Bowes User Guide April 2020
Safety
21