Table of Contents
Advertisement
Water Inlet & Drain Hose and Power Cord
■ How to connect inlet hose and joint
Connect the inlet hose to the joint. If you hear a
click sound when pulling down the part of the
water inlet hose, it indicates that the hose has
been automatically connected.
(Pull down the water inlet hose to make sure the
hose will not be pulled out).
■ How to connect the inlet hose and inlet valve
Fit the nut part of the inlet hose onto the thread
part of the inlet valve.
※
Never fold the water inlet fold to prevent leaks.
Inlet valve thread
Nut
Bend
Slightly raise the bend to tighten the nut.
※
Confirm that the nut has been reliably
tightened, and that the bend is not loose.
■ How to remove water inlet hose
Loosen the four screws at the joint using
a cross-head screw driver in anticlockwise
direction.
Caution
-
Be sure to tighten nuts to prevent water leaks.
-
Be sure to use the new fittings supplied as
accessories.
-
You can buy a water inlet hose that is long
enough at a local service center recognized
by Panasonic if the supplied hose is not long
enough.
10
Drain hose
Caution
Never distort, draw or bend the drain hose.
Be sure to insert the drain hose into the drain
hose duct. The height of the drain hose shall
not exceed 1m.
Caution
-
Never obstruct the drain hole of the wash
basin and ensure that the drained water
flows smoothly.
-
Never immerse the end of the drain hose in
water that has been drained off. Otherwise,
water may flow back to the washing machine
again.
Connecting Power
Nameplate
（ Back of the Box)
Caution
-
The standard for the rated power of the washing
machine are indicated on the nameplate. Please
confirm if the power used at your home conforms
to the standard.
-
Never insert the power plug of the washing machine
into an extension line or a multi-hole socket.
-
In case of defective power cord or power plug, do
not use them/it, and contact a service center
recognized by Panasonic for replacement.
Installation Checklist
3
4
2
5
1
6
3
5
Anchor bolts
1
Have you removed them and attached
the cover caps properly?
Location
2
Is the appliance on a flat, stable
surface?
Does it run without vibrating?
Inlet hose
3
Is it free from leaks?
Is the water supply normal?
Drain hose
4
Is it free from leaks?
Does it drain normally?
Adjustable stands
5
Are they bolted securely to the
appliance?
Power supply
6
Is the household dedicated mains
socket, fully rated at AC 220 V to 240 V?
Check after Installation
Trial operation after installation
Check if water leaks and abnormal noises
occur, and if drainage functions properly
after the installation.
Carry out the following operations when no
laundries are available in the drum.
1.Turn on the water tap.
2.Close the door.
3 . . Press 【 Power 】 button to power on
the machine. Select 【 Tub Clean 】
button and press 【 Start /Pause 】
button.
Confirm the following:
-Is there any abnormal noise?
If yes, confirm that the washing machine
is stable.
-Is there any water leakage?
If yes, make sure that the water hose has
been properly connected.
The following errors may occur:
- Is the drain hose properly connected?
- Is the drain hose blocked?
- Is the water inlet hose properly
connected?
- Is the water tap been turned on?
11
Hide quick links:
Advertisement
Table of Contents
